Users Also Read
MCQ's Search Engine
Electrical Engineering
Mechanical Engineering
Civil Engineering
Automobile Engineering
Chemical Engineering
Computer Engineering
Electronics Engineering
Medical Science Engg
All Engineering Dictionary Terms
Definition of "BNC Termination" |
A resistive termination used with BNC connectors, normally 50 ohms. Also refer to Dummy Load. / A connector with a single mating section that is used to terminate a BNC cable run. A BNC Termination holds either a 50 or 75 ohm resistor to terminate the line. The resistor is connected between the center pin contact signal and the outer shell ground. / Emphasis is the intentional alteration of the amplitude-vs.-frequency characteristics of the signal to reduce adverse effects of noise in a communication system. |
Please type any word or choose alphabet below... |
A
B
C
D
E
F
G
H
I
J
K
L
M N O P Q R S T U V W X Y Z 1 2 3 4 5 6 7 8 9 0 |