Users Also Read
MCQ's Search Engine
Electrical Engineering
Mechanical Engineering
Civil Engineering
Automobile Engineering
Chemical Engineering
Computer Engineering
Electronics Engineering
Medical Science Engg
All Engineering Dictionary Terms
Definition of "Point-To-Point Construction" |
Point-to-point construction refers to a non-automated method of construction of electronics circuits widely used before the use of printed circuit boards and automated assembly gradually became widespread following their introduction in the 1950s. Circuits using thermionic valves vacuum tubes were relatively large, relatively simple the number of large, hot, expensive devices which needed replacing was minimised, and used large sockets, all of which made the PCB less obviously advantageous than with later complex semiconductor circuits. Point-to-point construction is still used to construct prototype equipment with few or heavy electronic components. / Use of radio frequency bands of the electromagnetic spectrum is regulated by governments in most countries, in a Spectrum management process known as frequency allocation or spectrum allocation. |
Please type any word or choose alphabet below... |
A
B
C
D
E
F
G
H
I
J
K
L
M N O P Q R S T U V W X Y Z 1 2 3 4 5 6 7 8 9 0 |