Users Also Read
MCQ's Search Engine
Electrical Engineering
Mechanical Engineering
Civil Engineering
Automobile Engineering
Chemical Engineering
Computer Engineering
Electronics Engineering
Medical Science Engg
All Engineering Dictionary Terms
Definition of "Jumper" |
A short length of wire used to complete a circuit. A small plastic case with two female receptacles [shunt] used to short two adjacent contacts or pins, normally on 0.1 inch centers. The term may also describe a Zero Ohm Resistor. A jumper is usually used with a 2-pin header. Header Manufacturers. / An electrical connection between two points. / In electronics and particularly computing, a jumper is a short length of conductor used to close a break in, or bypass part of, an electrical circuit. Jumpers are typically used to set up or configure printed circuit boards, such as the motherboards of computers. / Gigabit Interface Converter is a transceiver that converts electric currents digital highs and lows to optical signals, and optical signals to digital electric currents. The GBIC is typically employed in fiber optic and Ethernet systems as an interface for high-speed networking. The data transfer rate is one gigabit per second 1 Gbps or more. / a plug or wire used for setting the configuration of system. It can be used for changing the hardware configuration by forcing some line to be high or low. It is used to change software configuration (especially on embedded systems) when the status of the jumper is read by the microprocessor. |
Please type any word or choose alphabet below... |
A
B
C
D
E
F
G
H
I
J
K
L
M N O P Q R S T U V W X Y Z 1 2 3 4 5 6 7 8 9 0 |